classictbird.com
  • Home
  • |
  • My Account
  • |
  • Login
  • |
  • View Cart
Electrical  /  Charging & Starter

Alternator Install Kit - 12 Volt - 1 Per car

Item Number: ALTKIT
Alternator Install Kit - 12 Volt - 1 Per car
 Review Average:  
 Number of Reviews: 4
 View Reviews
Unit Price: $239.00
Quantity 
 
 
 Detailed Description

Replace your generator with CASCO's Re-Manufactured high output 105 amp alternator. Easily satisfy all your auxillary electronics - whether it's halogen lamps, air conditioning, auxillary cooling fans, or high power radio.

This unit is internally regulated.

You do not use the original regulator. However this kit uses the old regulator as a place to connect some wires.

Requires working indicator light to energize.

Removal of battery will kill the engine. Winding is Delta. Amperage is 105.
Starts charging as soon as car is started. Manufacturer warranty - 2 yrs.

Removing the generator bracket requires removing a bolt that goes into the coolant system.  Plan to drain enough coolant out of the system to avoid a large coolant spill.

Designed to fit original cast iron generator bracket which has an inside dimension of 5 1/4".

Install Directions


 Product Reviews
Absolutely Perfect!!
Original Ford generator in my 56 wasnt charging battery at idle and charging under way wasnt adequate to avoid an eventual dead battery!! It was time for an alternator and this one is perfect. And, the installation instructions are spot on!! CASCO didnt miss a thing!!
- Richard Sponenbergh, AZ
 
This is a great product!!
Just replaced the original Ford generator in my 56. The generator would not start charging the battery until about 1200 rpms and I didnt want to mess with the voltage regulator. This alternator slipped right into my original bracket. The wiring diagram and installation, including the note about draining the coolant, are outstanding to the last detail!! Once the battery is fully charged, the alternator voltage output drops down to 10.5 volts to avoid overcharging the battery.
- Richard Sponenbergh, AZ
 
Well made product
The Alternator mounting point was just a little bit too wide for the OEM Generator bracket. Removed with a Flex 1 or 2 mm of material from the Alternator.
Robert Quillen
 
Well made product
Complete change took less then 30 minutes with new engine compartment cable assy.
- Robert Quillen, INT
 




  • About Us
  • |
  • Classified Ads
  • |
  • Contact Us
  • Full Site
Order Management System powered by MOM and SiteLINK7